16mm Test Tube Feeder

Designed & Produced by AntsDIY Trading (3207878-U)

“Feeding ant colonies that are in test tube setups has always been a pain in my butt. I remember feeding and cleaning 100 colonies in test tubes actually took me about 4 hours. That’s a lot of time. Until I found this concept online. But I don’t really trust those designs, so I made it my own. It has O-ring in it which will hold the test tube securely, the test tubes won’t be rolling around, and u can clean and feed the ants easily. Just remember to wash the feeding dish if it is dirty.”
– DavFoo

Disclaimer:
Do allow some minor warping at the base of the prints. Warping occurs due to material shrinkage while 3D printing, which causes the corners of the print to lift and detach from the build plate.